Cleaning And Maintenance - CityBug ES10 2 Benutzerhandbuch

7. Riding
1. Press the power button to turn on the system.
2. Push the scooter forward over 3kmph in order to engage the motor.
3. While gliding, gently push the throttle to start the motor.
4. If you wish to slow down, use the brake leaver to cut the power.
5. If you wish to stop, step on the mudguard to brake.
CAUTION: HOT! The brake system can generate extensive heat while in use. Do not
touch the brake system with bare hand under any circumstances.

8. Cleaning and Maintenance

● Always disconnect the product from the charger first, cover the charging
waterproof plug, turn off the power of the product, and avoid fluid contact with
the battery, motor and other electronic parts during cleaning to avoid unforeseen
hazards.
● Do not use a high-pressure water jet to clean the product or soak it in water.
● Do not use thinner or other solvents to clean the product.
● The brake lever response can be adjusted as in the above picture. Lock the
locking ring after adjustment.
11