General Safety References; Bitzer Green Point; Factors Influencing The Inspection And Replacement Intervals - Bitzer Sw-170-2 Bedienungsanleitung

1.4.1 General safety references

For work on the compressor once it has been commissioned
WARNING
The compressor is under pressure!
Serious injuries are possible.
Depressurize the compressor!
Wear safety goggles!
CAUTION
Surface temperatures of more than 60°C or below 0°C.
Risk of burns or frostbite.
Close off accessible areas and mark them.
Before performing any work on the compressor: switch it off and let it cool down or warm up.
2

BITZER Green Point

The Green Point service centers are the service branch of BITZER. They offer a variety of services for our
products, such as:
• Supply and sale of BITZER original spare parts and refrigeration oils
• Maintenance, repair and remanufacturing according to established standards
Further information can be found here.
Use the eParts software on the BITZER website to select the spare parts.
3

Factors influencing the inspection and replacement intervals

The lifetimes of the compressor components are determined by several influences. Any serious statement on in-
spection and replacement intervals of compressor components is only possible with restrictions. The information in
this document is based on empirical values.
BITZER recommends logging of the operating data with the compressor module CM-SW-01 for CSW105 or with
the optional protection device SE-i1 for CS.6 to CS.9. Use the BEST SOFTWARE from the BITZER website to ana-
lyse the data.
Influences are:
• Operating conditions
– Operating pressures,
– Suction and discharge gas temperature,
– Oil temperature
• Oil type and operational viscosity
• Refrigerant
• Amount and frequency of liquid floodback out of the evaporator
• Cycling rates
• Time after start until stable conditions are achieved
• Compressor oil level at start
SW-170-2 // PDF Download 10