Cleaning And Maintenance - Gymrex GR-MG120 Bedienungsanleitung

b) SET
Sets the operating values of the device: time, speed, calories, distance, ODO
c) RESET
When pressed, the device value is reset to zero.
LCD PANEL FUNCTIONS
Name
TIME
SPEED
DISTANCE
CALORIES
ODO
PULSE
SCAN
CAUTION! GR-MG121, GR-MG122 Models have only a "MODE" button!
CAUTION! When the device is not used, the LCD will turn off after 4-5
minutes!

3.4. Cleaning and maintenance

a) Use only non-corrosive products for surface cleaning.
b) Store the device in a cool and dry place, protected from moisture and direct
sunlight.
c) It is forbidden to spray the device with a stream of water or immerse the device
in water.
d) Regularly inspect the device for serviceability and any damage.
e) Use a soft cloth for cleaning.
f) Do not leave the battery in the device when it will not be used for a long time.
g) Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) for
cleaning as these may damage the surface of the device material.
h) Do not clean the device with acidic substances, medical agents, thinners, fuel,
oils or other chemicals as this may damage the device.
i) It is necessary to oil the ejection points of the device periodically.
j) Before each use, check the device fixings and tighten if necessary.
INSTRUCTIONS FOR SAFE DISPOSAL OF ACCUMULATORS AND BATTERIES.
The devices are equipped with AAA 1.5V and AA 1.5V batteries.
Position
Total exercise time
Current speed
Distance travelled
Number of calories burned
Total distance travelled (counted from the time the batteries
were connected)
Current heart rate. Place your hand over the sensor opening.
After approx. 3 seconds the result should appear
Automatic display of functions every 6 seconds. (TIME,
SPEED, DISTANCE, CALORIE, ODO, PULSE