Gymrex GR-MG 50 Bedienungsanleitung Seite 22

a) Connect the upper frame (1) to the lower base (3). For this purpose, align the
axes of the frame and base holes at the connection point. Fasten with M12x35
screws, M12 washers and M12 nuts. Slide the washer onto the fixing screw.
Pass it from the top of the frame through the axes of the holes. Attach with
washer and nut.
b) Fasten the backrest bracket (9) to the bottom base (3). Align the axes of the
backrest and base bracket holes at the connection point. Apply a 180x56
reinforcing plate on the outside. Fix the structures with M12x130 screws, M12
washers and M12 nuts.
c) Fasten the load holder (15) to the upper frame of the machine (1). Pass the
holder pin through the hole axis. Secure on the outside with M10 washer and
M10 nut. Repeat installation for all handles.