Texas CS 3600 Montageanleitung Seite 5

Assembly
Install impeller (O) on the gearbox
(M), secure with screw (D) in the
bottom hole.
Insert the lower handle (Q) on each
side of the gearbox axis, mount
fixing-rod (P) on the lower
handle(Q) fasten with bolt (B).
Ensure that the gear is turned
correctly (see label on the gear)
A: Insert the rotor axis of the
gearbox (M) through the bottom of
B
A
the hopper (N) fix the R-pin (K) to
the gearbox (M) from the inside of
the hopper (N)
B: Insert bolt (A) through the
A
inside of the hopper (N) continue
through the support-leg (S), fix
with washer (H) insert the bolt (A)
further through the handle (Q)
fasten with nut (E)
Insert the bushing (I) onto the
wheel axis of the gearbox (M)
lock the bushing (I) in the
handlebar (Q)
Install the right wheel(L) and
tighten with bolt(C) and nut(F)
secure the wheel from the outside
with hubcap (J).
Install the left wheel(L) plus
washer(G) on the outside of the
wheel, secure the wheel with the
hubcap(J).
Attach the handlebar (R) at the
support-leg(S), secure with bolt(B)
and nut(E)
Attach the cable from the
hopper(N) onto the dispenser le-
ver on the handle(R) fasten cable
onto the bracket below the lever.
5
5