Levenhuk Discovery Report WA60 Bedienungsanleitung Seite 6

Discovery Report WA60 Weather Station
EN
The kit includes: base station, wind sensor, rain gauge, DC adapter, user manual, and warranty.
Caution! Please remember that mains voltage in most European countries is 220—240V. If you want
to use your device in a country with a different mains voltage standard, remember that use
of a converter is absolutely necessary.
Getting started
Base station
• Connect the power cable to the device and connect the DC adapter to the AC power supply; or
• Open the battery compartment cover (20) and insert 3 batteries according to the correct polarity. Close the
cover.
NOTE! It is recommended to use an adapter for the continuous operation of the base station, although
battery power is also possible. In battery mode, the backlight turns on only for a short period of time.
• Once the batteries are installed, the base station will search for the outdoor units for the first 5 minutes. After
that, the base station can be manually set to receive. To do this, press the CHANNEL button for 2 seconds.
• The effective range may differ depending on the unit's position. Due to interference (various remote control
devices, etc.), the maximum distance between the base unit and the outdoor unit may be significantly
reduced. In such cases, we suggest moving the base unit and sensor a little. Sometimes it is enough to move
one of these units just a few inches!
Wind sensor
• Place the base station and the remote sensor within the effective transmission range. Open the battery
compartment cover (3) and insert 4 batteries according to the correct polarity.
• Set the channel switch (8) to the same channel selected on the base station, and then press the TX button.
Check that the base station has received the signal. Press the TX button once more, if necessary. If the
reception is successful, the base station display will show the temperature and humidity. Close the battery
compartment cover.
• Insert the aluminum pole (2) into the mounting base and fasten it with the screws (included). Screw the base
to a wooden or stone wall using the supplied screws and plugs. Slide the upper part of the wind sensor onto
the pole and fasten it with the screws.
• The wind speed sensor, temperature, humidity, and wind direction part must be facing south. Orientate the
outdoor wind unit using the compass to ensure the correct wind direction.
Rain gauge
• Open the battery compartment cover (6) and insert 2 batteries according to the correct polarity. Close the
cover and secure it with the screws.
• Fasten the rain gauge by inserting the screws through the mounting feet (3). To replace the batteries, first
unscrew the rain gauge.
Time setting
Press the MODE button. Hold the SET button for 3 seconds. The digits that are to be set are flashing. Press UP
or DOWN to change the value, and then press SET to continue.
The setting order: Time zone > Day Saving Time > Year > Month-Day or Day-Month > Month > 12/24h > Hour >
Minutes > Seconds.
Alarm setting
• To activate alarm 1 and/or alarm 2, press the ALARM button.
• To set alarm 1 and alarm 2, first press the MODE button 2 times. Hold the SET button for 3 seconds. The digits
that are to be set are flashing. Press UP or DOWN to change the value, and then press the SET button to
continue.
• The setting order: Alarm 1 hours > Alarm 1 minutes > Alarm 2 hours > Alarm 2 minutes.
• When the alarm rings, press SNOOZE/LIGHT to activate the snooze function. The alarm will sound again
in 5 minutes.
• Press any button to silence the alarm until the set alarm time is reached again.
Atmospheric pressure height setting
Press the MODE button 3 times. Hold the SET button for 3 seconds. The digits that are to be set are flashing. Press
UP or DOWN to insert the desired height.
6