Leonard LAS6001F Benutzerinformation Seite 11

8.1 What to do if...
Problem
You cannot activate or operate
the hob.
You can hear a constant beep
noise.
An acoustic signal sounds and
the hob deactivates.
An acoustic signal sounds
when the hob is deactivated.
The hob deactivates.
Residual heat indicator does
not come on.
The control panel becomes
hot to the touch.
comes on.
and a number come on.
Possible cause
The hob is not connected to an
electrical supply or it is connected
incorrectly.
The fuse is blown.
You do not set the heat setting for
10 seconds.
You touched 2 or more sensor
fields at the same time.
There is water or fat stains on the
control panel.
The electrical connection is incor‐
rect.
You put something on one or
more sensor fields.
You put something on the sensor
field .
The zone is not hot because it op‐
erated only for a short time or the
sensor is damaged.
The cookware is too large or you
put it too close to the control pan‐
el.
Child Safety Device operates.
There is an error in the hob.
Remedy
Check if the hob is correctly con‐
nected to the electrical supply.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Activate the hob again and set the
heat setting in less than 10 sec‐
onds.
Touch only one sensor field.
Clean the control panel.
Disconnect the hob from the electri‐
cal supply. Ask a qualified electri‐
cian to check the installation.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
Put large cookware on the rear
zones, if possible.
Refer to "Daily use".
Deactivate the hob and activate it
again after 30 seconds. If
comes on again, disconnect the hob
from the electrical supply. After 30
seconds, connect the hob again. If
the problem continues, speak to an
Authorised Service Centre.
ENGLISH 11