Operation; Attaching Or Replacing The Grinding Disc - Silk'n FRESHPEDI FTC03 Bedienungsanleitung

• Always unplug the product after charging
EN
has been completed.
• Fully charge the product before first use and when the
• The remaining battery power level shows in the
• The product cannot be used during charging.
1. Plug the smaller end of the USB cable
port
5
2. Plug the larger end of the USB cable into the USB port of a
compatible USB power source (e.g. USB power adapter) for
charging.
Charging starts automatically. The current battery power level
shows in the display (indicated by %).
3. When charging is done, unplug the USB cable from the
charging port and the USB power source.

6 Operation

• Before treating an area of your feet for the first time,
• You can purchase new grinding discs on our website at

6.1 Attaching or replacing the grinding disc

The product includes 3 grinding discs
and Coarse). Start with the Fine grinding disc until you are sure
there is no adverse reaction.
1. Remove the cover
2. Remove the attached grinding disc from the product.
If necessary, attach the hooks of the disc remover
grinding disc and then pull it up to remove the grinding disc
(see step 1 in Fig. B).
3. Gently push the desired grinding disc onto the spindle of the
grinding head
You will hear a click sound when the grinding disc is securely
snapped into place.
11
battery power is low.
display (indicated by %). Recharge the product
6
when the battery power is low.
of the product.
perform a skin sensitivity test on a spot on your foot
for maximum 3 seconds. Start your treatment only if
there is no adverse reaction.
www.silkn.eu.
if it is attached to the product.
9
(see step 2 in Fig. B).
2
into the charging
11
/ / (Fine, Medium
8 1 7
10
to the