Basic Instructions - Dual DL-P06-002 Bedienungsanleitung

FITTING THE DUST COVER
Refer to the diagram below to attached the plastic dust cover.
Take care when fitting, and do not press down to hard. Remove the dust cover in the same manner, but
pull the cover upwards.

BASIC INSTRUCTIONS

SET-UP: Place your turntable in a secure location where it will be protected from

the elements or possible falls.
 POWER CONNECTION: Connect the power by 5V DC adaptor.
LIFT THE DUST COVER: Lift the dust cover and keep it open when in use.

TURN ON: Turn on the Power Switch, note that this also controls volume.

SPEED SELECTION: Select the speed between 33, 45 and 78 rpm through speed

switch.
INSERT THE RECORD: Carefully remove the record from its case and place the

record on the turntable plate.
MOVE THE NEEDLE: Release the tone arm lock, slowly and gently move the

needle over the record, placing it on the outermost part of therecord.
DROP THE NEEDLE: Once the needle is over the record, use the small lever on

the base of the needle and press down to lower it onto the record.
ENJOY YOUR MUSIC: Once above steps are completed, press the "Play mode"

select key the turntable will start turning automatically.
FINISHING UP: Lift up the tone arm and put it on the rest when finished, turn off

the Power Switch. (the turntable will stop automatically if the auto-stop switch is in
the "ON" position. If the switch is in the "OFF" position then it will keep revolving
until the tone arm is moved.)
16