Accessories Installation - eeese 1420 Bedienungsanleitung

UK
Winter Cover, 1 pc
Water drainage pipes, 2 pcs

4.2 Accessories Installation

Anti-vibration bases
1. Take out 4 Anti-vibration bases
2. Put them one by one on the bottom of
machine like the picture.
Draining jet
1. Install the draining jet under the bottom
panel
2. Connect with a water pipe to drain out
the water.
Note: Lift the heat pump to install the jet.
Never overturn the heat pump, it could dam-
age the compressor.
Water Inlet & outlet junction
1. Use the pipe tape to connect the water
Inlet & outlet junction onto the heat pump
2. Install the two joints like the picture
shows
3. Screw them onto the water Inlet & outlet
junction
128 MV-1420-1421-04-2022 . eeese-aircare.com . © All rights reserved eeese air care ApS