Werbung
Verfügbare Sprachen
Verfügbare Sprachen
English
Application
The letter flap BE 611-... is used
at the front of the BKV 611-... or
mounted individually as a letter flap
for doors or door side panels. The
pass-through opening can be indi-
vidually adjusted prior to mounting.
It is possible to completely close the
pass-through opening.
Scope of supply
• Letter flap BE 611-...
• This product information
Mounting
1 The mounting block in the
BKV 611-... is ideally prepared
for integration of the BE 611-...
in flush-mounted letterboxes.
Adjustment of up to max. 15 mm is
possible to align with the plaster. To
adjust, release the fastening screw.
Place for example a spirit level over
the opening and push the fastening
block with the two support shoul-
ders against it. Tighten the fastening
screw again.
2 The pass-through opening of
the BE 611-... can be individually
defined as required.
a Pass-through opening for the
BKV 611-... (condition on delivery)
b Pass-through opening in accord-
ance with DIN EN 13724
c Pass-through opening of 18 mm
for improved security against pil-
fering.
d Pass-through opening closed
for temporary periods of disuse or
absence, such as holidays.
To adjust the pass-through opening,
release the position screw at the side
of the BE 611-..., change the pass-
through opening accordingly and
replace the position screw.
3 Mounting the BE 611-...
Lay the combination frame over the
integrated letterbox housing, insert
the BE 611-... and screw on both
sides using the provided screws.
6
4 Mounting the combination
frame greater than KR 611-4/3-...
or KR 611-4/4-...
Short fixing brackets are provided
with the combination frame. These
are used to fix the KR 611-... in the
external corners of the BKV 611-...
These fixing brackets are only used
in conjunction with BKV 611-3/... or
BKV 611-4/...
5 Lay the KR 611-... over the let-
terbox unit and fix at the fastening
block using the provided screws.
6 (not illustrated)
Insert the BE 611-... in the letter-box
and fasten on both sides using the
Torx screws. (Screws and screwdriver
are provided).
7 Screw the mounting frame using
the enclosed quick-release screws
in the flush-mount housing, after a
quarter turn to the right (until the
stop).
8 (not illustrated)
Applying a light pressure, underpin
the module in the module slot of
the MR 611-... opposite the mov-
able locking bolt. Exerting a slightly
higher degree of pressure, clip into
place on the other side.
Mounting the BE 611-... as a
door pass-through letterflap
9 Installation dimensions
10 Final mounting of the BE 611-...
Lettering
11 Release the name-plate cover by
levering using a small screwdriver.
To replace the name-plate cover, clip
into place on the right and close by
exerting a slight pressure.
12 Open the letter removal door.
Pull the top part of the nameplate
cover on the inside of the letter
removal door towards you and hinge
upwards.
Close the cover in reverse sequence.
For optimum inscription possibili-
ties please use the Siedle lettering
service.
Care instructions
To retain the optimum appearance
of the Siedle door loudspeaker, we
recommend regular cleaning using a
mild soap, followed by rubbing dry
with a soft cloth.
Werbung
