Beyerdynamic CLASSIS BM 53 USB Produktinformation Seite 12

All manuals and user guides at all-guides.com
10
• Do not use passive extension cables, it might be
possible that the microphone is not recognised as
hardware component by your computer anymore.
• If you connect the microphone to a PC with the
operating system Windows
automatically as new hardware. A message that the new
hardware has been installed and is now ready for use
will be displayed.
• Due to system variability of computer hardware it is
not possible to determine general system require-
ments for an optimum operation of the Classis BM 53
USB.
• It is not possible to guarantee the operation of the
Classis BM 53 USB with any PC configuration.
• Now before you can use the microphone for recordings
you must select the correct device for sound recording
and the recording level.
– Select Control panel. Open the menu item Sounds
and select the index card Sound recording.
Depending on the PC configuration you must
select the standard device ClassisBM53USB or
USB-Audio device for the Classis BM 53 USB.
• As the Classis BM 53 USB is a mono microphone, the
balance control cannot be shifted.
Use with the beyerdynamic steno-s Software
If you use the Classis BM 53 USB with the steno-s
recording software, you must select some settings in the
steno-s program:
• Select in the recording window under Options /
General settings the index card Recording parameters
and select ClassisBM53USB for your microphone
under Selection recording device.
Troubleshooting
The microphone is switched on, the red LED is illuminated,
but there is no data transmission.
• Check if the USB plug has been connected to the
microphone correctly.
The recording volume is lower as set before.
• If you disconnect and reconnect the microphone, the
Classis BM 53 USB – Boundary Microphone
® , the microphone is found