MONTE STIVO Flyweight Bedienungsanleitung Seite 16

EN
16
Optional: Change subchannel (CTCSS)
Each channel has 99 subchannels. The current channel and subchannel are
indicated by the large and small numbers in the upper right corner of the
display.
Note: Change only the channel (see Change Channel) and leave the
subchannel untouched. A change is only necessary if all channels are
occupied or disturbed.
To change the subchannel, press the MENU key
subchannel flashes on the display. Press the UP or DOWN key
one of 99 available subchannels, then press the PTT key to confirm the
selected subchannel.
Note about the channel: To communicate, both walkie-talkies must be set to
the same channel and subchannel.
Searching for active radio channels
Press and hold the UP button
on the display and the unit continuously cycles between channel 1 to channel
8. Once an active channel is found, the scan stops and the transmission
starts. If the transmission stops on the found channel, the scan will continue
automatically. In this case, press the PTT button to keep the one channel and
stop the search.
Locking and unlocking the device
Press and hold the MENU key
Switching the confirmation signal (roger tone) on and off
After the PTT key is released, the device sends a beep to confirm that the
transmission has ended. The so-called roger signal tone can be deactivated
in the menu. To do this, press the MENU key
on the display. Press the UP or DOWN key
roger tone and confirm the selection with the PTT key.
2 times . The current
for 2 seconds. The indication [SCAN] appears
for 3 seconds to lock or unlock the device.
four times until [RO] is shown
/ to activate or deactivate the
/ to select