MONTE STIVO Flyweight Bedienungsanleitung Seite 15

Receiving and transmitting messages
After switching on, the device is immediately ready for use and is in receive
mode. When a signal is received on the current channel, the display shows the
reception and the message becomes audible. As soon as the PTT (push-to-talk)
button is pressed, the device switches to transmit mode.
Note: It is only possible to transmit OR receive.
The device will send a „roger tone" at the end of each message, signaling when
the other party's message has ended. To speak, press and hold the
PTT button and speak into the microphone (3-5 cm from your mouth) in a
normal voice. When the message is finished, release the PTT button.
Range note: The range depends on the environment and conditions and will
be affected by obstacles such as hills, buildings or other equipment. Do not
use the two walkie-talkies when they are less than 1.5 m apart. Doing so may
cause unpleasant noise interference.
Send call tone
Press the PTT button twice in quick succession to send a call tone on the
current channel.
Change call tone
The device has 10 call tones. Press the MENU button
succession until the display shows [CA]. Press the UP or DOWN button
to change the call tone, and then press the PTT button to confirm the selected
call tone.
Change channel
Press the MENU button
appears on the display. Press UP or DOWN button
and then press PTT button to confirm selected channel.
once to change the channel. The channel number
three times in
/
/ to change the channel
EN
15