Automatic Washing/Drying Cycle - De Dietrich DLZ1854I Bedienungsanleitung

9. AUTOMATIC WASHING/
DRYING CYCLE
You cannot exceed the maximum
dryable load of laundry indicated in
the programme table, otherwise the
laundry will not be dried satisfactory.
- Washing
Open the drawer and put in the correct

amount of detergent.
Refer to the list of washing programmes

for the fabrics to be washed (e.g. very
dirty cotton) and turn the selector knob to
the required programme.
Adjust the wash

necessary.
Press the option buttons (if required).

Check that the tap is turned on and that

the discharge
correctly.
- Drying
Select the degree of dryness that you

require:
EXTRA DRY
(suitable for towels, bathrobes and
bulky loads).
IRON DRY
(that leaves the laundry ready for
ironing).
CUPBOARD DRY
(for items that will be put away
without ironing).
If you wish to select a timed drying

programme, press
SELECTION button until the required
time indicator lights up.
Press the START/PAUSE button.

temperature
hose is positioned
the DRYING
92
At the end of the wash phase the display

will show the drying time remaining.
The drying programme indicator will be

on, until the cool down phase begins and
the corresponding indicator is on.
When the programme is finished the word

"End" will appear on the display. After 5
minutes the appliance will go into
standby mode (on certain models, the
display will show two lines).
Switch off the machine by turning the

programme selector to the OFF position.
Open the door and remove the laundry.

Turn off the tap.

if
CANCELLING THE DRYING PROGRAMME
To cancel the drying programme, press

and hold the DRYING SELECTION
button for about 3 seconds.
WARNING:
After cancelling the drying programme,
the cool down phase will begin and you
must wait for about 10/20 minutes
before opening the door.
In order to ensure the correct operation
of the appliance, it is advisable not to
interrupt the drying phase unless it is
absolutely necessary.