Digital-Display - De Dietrich DLZ1854I Bedienungsanleitung

An over dosing of detergent can
cause excessive
appliance detects the presence of
excessive foam, it may exclude the
spinning phase or extend the duration
of the program and increase water
consumption.
The machine is fitted with a special
electronic device, which prevents the
spin cycle should
unbalanced. This reduces the noise
and vibration in the machine and so
prolongs the life of your machine.
KEY LOCK
 Pressing simultaneously
TEMPERATURE SELECTION and SPIN
SPEED for about 3
machine allows you to lock the keys. In
this way, you
accidental or unwanted changes if a
button on the
accidently during a cycle.
The key lock can be simply cancelled by

pressing the two buttons simultaneously
again or turning off the appliance.
Digital Display
The display's indicator system allows you to
be constantly informed about the status of
the machine.
1) DOOR LOCKED INDICATOR LIGHT
The indicator light is illuminated when the

door is fully closed.
foaming. If the
the load be
the buttons
seconds, the
can avoid making
display is pressed
84
Close the door BEFORE selecting the
START/PAUSE button.
When START/PAUSE is pressed on the

machine with the door closed, the
indicator will flash momentarily and then
illuminate.
If the door is not properly closed,
the light will continue to flash for
about 7 seconds, after which the
start command will be automatically
delete. In this case, close the door
in the proper way and press the
START/PAUSE button.
Wait until the DOOR LOCKED light has

gone out before opening the door.
2) SPIN SPEED
This show the spin speed of the selected
programme that can be changed or omitted
by the relevant button.
3) WASH TEMPERATURE INDICATOR LIGHTS
This shows the washing temperature of the
selected programme that can be changed
(where allowed) by the relevant button.
If you want carry out a cold wash all the
indicators must be off.
4) CYCLE DURATION
 When a programme is selected the
display automatically shows the cycle
duration, which can vary, depending on
the options selected.
Once the programme has started you will

be kept informed constantly of the time
remaining to the end of the wash.
The appliance calculates the time to the

end of the selected programme based
upon a standard loading, during the cycle,
the appliance corrects the time to that
applicable to the size and composition of
the load.