Wilfa COOL 9 CONNECTED Anleitung Seite 25

Air conditioner Is normal operation
can't receive interrupted by events
signal from remote such as static pressure,
controller or unstable voltage?
remote controller
is not sensible. Is the remote controller
within the receiving
range?
Does any physical
obstacles block free
sight between remote
and unit?
Is sensitivity of remote
controller low?
Is there a fluorescence
lamp in the room?
No fan blowed Is the air outlet or inlet
out from air blocked?
conditioner.
Is the filter dirty?
Set temperature Has the unit been set to
can't be adjusted. auto mode or has child
lock been activated?
Is the room temperature
within the temperature
range for the unit?
There is off flavour. There's off flavour
source in the room, such
as furniture, cigarette
etc.
There's abnormal Were the unit interfered
sound during by thunder, radio, etc?
Operation.
AIR CONDITIONER · COOL 9 CONNECTED
23
Please pull out the plug. Insert
the plug after about 3min, and
then turn on the unit.
The receiving range of remote
controller is 8m. Do not
exceed this range.
Remove the obstacles.
Check the batteries of remote
controller. If the power is low,
please replace the batteries.
Move the remote controller
close to air conditioner.
Turn off the fluorescence lamp
and try it again.
Eliminate the obstacles.
Clean the filters.
Temperature can't be adjusted
under auto mode. Child lock
can be unlocked by pressing
"+" and "-".
Temperature setting range:
16°C-30°C.
Remove the off flavour source.
Clean the filter.
Disconnect the power, put the
power on again, then turn on
the unit.
EN