Led Indicators - Red Sea ReefMat Benutzerhandbuch

Thread the power-supply out the rear of the cabinet and insert it into the
wall outlet or other suitable power center. Check that the indicator LED on
front of the drive-unit is on.
Onboard the drive-unit to the ReefBeat App and complete the initial setup
before installing the fleece-mat.

LED Indicators

Power Indicator:
• Solid Red light – DC power is available.
• No Red light – DC power is not available.
Settings Indicator:
• Solid Red light – ReefMat is connected to the Home network.
• Blinking Red light – ReefMat is in Wi-Fi Access Point (AP) mode
(can be discovered by Wi-Fi devices).
• No Red light – ReefMat Wi-Fi is off.
• Double blink – indicates change of status / end of process.
Status Indicator:
• No Red light – ReefMat is operating normally.
• Blinking Red light – indicates that the Auto-Advance mode has
been suspended for one of the following conditions: High-
Water, Level sensor disconnected, Jammed-Mat, End-of Roll.
Simultaneous pressing of the wind/unwind buttons resets
the ReefMat to Auto-Advance mode.
Red Sea ReefMat
®
ENG
15