Yedoo YOOTOO Bedienungsanleitung Seite 8

Assembly Instructions
1.
YooToo, TooToo, 112
Before assembly, remove the plastic
covers from the front and rear wheel
axis.
Handlebar installation
Place the handlebar into the main frame
tube (1) of the balance bike, adjust the
desired height and tighten the screw on
the stem (2).
1.c
Place the sleeve screw exactly
on the cut-out of the fork tube
as on the picture.
EN
1.a
2
10 Nm
1
OneToo
Before assembly, remove the plastic
covers from both front and rear wheel
axis.
Handlebar and front fork installation
Remove the sleeve cover, the sleeve
itself and upper the headset ring
from the front fork. At installation,
the headset composition must be
as on the picture.
1.d
Put the sleeve cover (1) on the handlebar
tube and place it into the fork tube (2).
Adjust the heigh as desired (do not
exceed the maximum mark) and tighten
the screw on the sleeve (3).
1.b
Insert the front fork into the main frame
tube (1) so that the bending of the fork
faces forward. Place the upper headset
ring (2) and the sleeve (3) back on the
front fork.
1.e
1
2
3 10 Nm
In the end, place the protective cover
over the sleeve.
3
2
1
8