Deltafox DP-CDR 2013 Originalbetriebsanleitung Seite 22

GB
batteries. Damaged or altered batter-
ies can be unpredictable and lead to
fire, explosion or risk of injury.
f) Do not expose batteries to fire or
elevated temperatures. Fire or tem-
peratures over 130 oC can cause an
explosion.
g) Follow all instructions for charging,
and never charge the battery or the
battery-powered tool outside the
temperature range stated in the in-
structions manual. Incorrect charg-
ing or charging outside the permitted
temperature range may destroy the
battery and increase the risk of fire.
6) SERViCE
a) have your power tool serviced by
a qualified repair person using
only identical replacement parts.
This will ensure that the power tool
remains safe.
b) never repair damaged batteries.
All battery repairs should be carried
out by the manufacturer or author-
ised customer service centres only.
7) SAFETy inFORmATiOn FOR
USinG LOnG DRiLLS
a) Do not work at a speed higher than
the maximum permissible speed
for the drill. Higher speeds can
cause the drill to bend slightly when
rotating freely without contact with the
workpiece and can also cause injury.
b) Always begin drilling at a low
speed and when the drill is in con-
tact with the workpiece. Higher
speeds can cause the drill to bend
slightly when rotating freely without
contact with the workpiece and can
also cause injury.
22
All manuals and user guides at all-guides.com
c) Do not apply excessive pressure
to the drill. Only apply pressure
lengthwise along the drill. Drills can
bend and break or cause a loss in
control, thus resulting in injuries.
SAFETy inSTRUCTiOnS
8)
FOR DRiLL SCREWDRiVER -
WORKinG inSTRUCTiOnS
i) hold the appliance by the insu-
lated gripping surfaces when
performing work in which the tool
may come into contact with hid-
den wiring. Contact with a live wire
can also cause a charge in metal
parts of the appliance and result in
an electric shock.
j) hold the device by the insulated
gripping surfaces when perform-
ing work in which the cutting tool
may come into contact with hidden
wiring or its own cord. If the screw
were to come into contact with a live
electrical cable, metal parts of the ap-
pliance could also become live and
cause an electric shock.
9) RESiDUAL RiSKS
Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the follow-
ing hazards:
a) Cuts
b) Ear damage if working without ear
protection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer
periods of time or if the unit is not
held or maintained properly.