Locate Charger; Battery Type & Settings; Mode Settings - Carpoint 06.358.62 Bedienungsanleitung

• Danger of explosion and fire! While charging, explosive and flammable substances such as fuel or solvents should not be kept in vicinity of
the charger or the battery.
• Do not cover the charger while charging.
• Danger of chemical burns! Battery acid is highly corrosive. If your skin or eyes come into contact with acid, immediately rinse the affected
part of the body with excessive water and seek medical advice.
• Do not charge a frozen battery
• Do not charge a damaged battery
• Before charging, make sure the input is within stipulated rating level, otherwise charging performance may be seriously affected.
• While connecting the charger to the battery, maintain right polarity connection and avoid short-circuiting.
• Disconnect the battery from the charger when charger is not connected to the power supply. This will reduce back drain current.
• Charging must be ceased immediately if battery is found to be too hot or leaks out liquid during charging.
• In case of malfunction or damage, immediately disconnect the charger from the mains.
• Do not use vehicle when charging permanently installed batteries.
• Ensure that charger switches to maintenance charge mode, before it is left unattended and connected for long time. If this stage does not
arrive within 73 hours (max), the charger must be disconnected manually.

Locate charger

• Locate the charger as far away from battery as the DC cord permits.
• While charging do not place charger directly above or below the battery. Gases or fluids from the battery may corrode and damage the
charger.
• Never allow battery acid to drip on the charger.
• Charging should be carried out in a well-ventilated, weather protected facility.
BatterY tYPe & SettIngS
The following recommendations should only be referred to as guidelines. For precise details, you must refer to battery manufacturer for
instructions.
Symbol

mode Settings

1 28.8V/3.5A
2 29.4V/3.5A
3 14.4V/7A
4 14.4V/7A
5 13.6V/5A Supply
6 16V/1.5A Boost
BOOST
details
This mode is normally suitable for 24V WET, MF and GEL batteries.
This mode is recommended for several 24V AGM batteries. It is also suitable for charging
batteries in sub-zero temperatures.
This mode is normally suitable for 12V WET, MF and GEL batteries.
This mode is recommended for several 12V AGM batteries. It is also suitable for charging
batteries in sub-zero temperatures.
a) Maintenance of 12V batteries: this mode is suitable for maintenance of 12V batteries
with capacity range from 14-230Ah. The charger delivers a constant voltage of 13.6V. This is
maintenance mode for applications where maximum capacity from the battery is required
such as Golf Carts, Floor Sweepers etc.
b) Power source: Carpoint battery charger is also used as a power supply, without attaching
a battery in this mode. The charger delivers 13.6V/5A. Spark free function is inactivated.
However reverse polarity protection function still works.
This mode is mainly applied for recovering 12V batteries with capacity range from 14-230Ah
in normal condition. To recover severely discharged batteries due to stratified acid, this mode
is useful. High voltage (17V max) at 1.5A is applied for a maximum period of 3 hours. A fully
charged battery gives faster result. High voltage may cause some water loss. For optimal
efficiency and minimum risk to vehicle's / boat's electronics, battery must be disconnected.
3