Contouring without the hair clipping comb attachment
1) R emove the hair comb (if it is attached). Be careful when you are clipping without comb
attachment as when the clipper is turned on it will trim every hair it touches.
2) T ilt the clipper in such a way that only one edge of the trimming attachment touches
the hair ends when you shape the contours around the ears.
Trimming facial hair
1) M ark a facial hair line with the trimmer and cut off the hairs exceeding this line from
the outer perimeter
2) I f you want to achieve an even trim of facial hair, use one of the attachments B1-B2
or trim carefully the ends by small pieces over the brush in such a way that the brush
moves through the hair upwards. Repeat the process in the whole facial hair area.
3) A fter trimming shave the parts around the beard in a usual way.
Trimming a mustache
Trim carefully over a brush to achieve an even cut of the mustache. If you prefer using your
finger as a guide, proceed accordingly.
Trimming Nose Hair
1) M ake sure nasal passages are clean.
2) P lace nose, ear and eyebrow attachment B3 on Clipper.
3) S witch the Clipper on and insert the tip of the attachment into one nostril.
4) S lowly move the tip in and out while turning it around at the same time in order to
remove unwanted hair. For best results, make sure the side of the tip is firm against
skin. This will reduce the tickling effect that can occur during trimming of nose hair.
5) T urn off Clipper. Wipe attachment clean after each use.
Do Not insert the tip more than 5 mm into your nostril.
Trimming Ear Hair
1) C lean outer area of ear and ear canal. Make sure it is free of wax.
2) N ose, ear attachment B3 should be on the Clipper.
3) S witch the Clipper on and move the tip softly around the edge of ear to remove hairs
extending beyond the outer ear.
4) C arefully insert the tip into outer ear canal.
5) T urn off Clipper. Wipe attachment clean after each use.
Shaving With Micro Shaver Attachment
1) P ut on the shaving attachment B4 on the appliance.
2) U se the narrow micro shaver to shave along contoured edges to remove any stubble
while creating a smooth welldefined beard line. Before using the micro shaver, always
check it for wear and damage. If the micro shaver shows signs of wear or damage, do
not use it as injury may occur. Do not use the micro shaver until it has been replaced.
3) G ently press the micro shaver onto the skin. Do not press too hard.
Do not insert the tip further than 5 mm into the ear.
CAUTION
CAUTION
27 / 43
GB