HANSGROHE AXOR Uno 14850 Serie Montageanleitung Seite 21

Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing
washer in position on the sink.
3. Slip the plastic washer, the slide washer,
the metall washer and collar over the hoses
and threaded base and tighten the collar nut
by hand. If there is not enough space,
please use only the slide washer and the
metal washer without the plastic washer.
4. Tighten screws.
5. Connect the supply pipes to the isolation
valves; cold right - hot left.
14855XXX: Connect a dish washer or a
washing machine to the thread DN20 (¾ ").
The hot and cold supplies must be of equal
pressures.
Technical Data
Operating pressure:
Recommended operating pressure:
MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
All manuals and user guides at all-guides.com
max. 1 MPa
0,1 – 0,5
1,6 MPa
max. 80° C
65° C
13 l/min 0,3 MPa
English
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15 MPa.
To adjust the hot water limiter on single lever
mixers, please see page _1b.
No adjustment is necessary when using a
continuous flow water heater.
Spare parts see page 4
1 handle
1.1 screw cover
2 flange
3 nut
4 cartridge cpl.
5 aerator (10)
6 fixing set
7 connection hose 900 mm
8 spout
9 sealing set
10 shut off unit, Elastop
XXX = Colors
000 chrome plated
750 alux
14896XXX
96338000
96468XXX
96461000
92730000
13913000
95049000
94082000
96514XXX
92646000
94849000
5