Using The Blender - eta Activmix Team Bedienungsanleitung

The knife section is treated with oil not harmful to health for technological reasons.
Put the blender on a flat, stable, smooth and clean work surface at the height of at least
85 cm, out of reach of children and incapacitated people (see par. SAFETY WARNING).
Make sure that the power cord is not damaged and that it does not lead through any sharp
or hot surfaces. Plug power supply fork A3 to the electric power. Possible short-time mild
smoke when the appliance is operated for the first time is not a defect and the appliance
is not subject to a complaint for this reason.
– If the dish is not fitted correctly on the propulsion unit, the safety switch will not allow
to put the motor in operation.
– When the blender is in the state of idle operation, e.g. the blade fails to touch the foods,
unplug the unit until the foods have been relaxed.
– Maximum time of operation is 60 sec., then leave the appliance rest and cool down for
approx. 2 min. If you process big amounts of food, divide them in separate portions so
that you keep) recommended times of operation and rest of the propulsion unit.
ACCESSORY INSTALLATION (pic. 2 – 7)
Bowl assembly and distribution (B)
Put sealing B1 on the contact surface of the plastic base of knife B2.
Hold the knife (on the bottom) at the plastic base and slide it (with the blade down) to the
hole in the filled container B, then turn it in the direction of the maximum position and tighten
with reasonable force. Remove the knife from the container in the opposite direction.
Check whether the sealing is put properly on its place in the bowl,
–
is clean and is not leakage of fluid.
Container (E) assembly process
Assemble the E container according to Fig. 2. To disassemble the container, apply the
reverse procedure. Put all ingredients in the container and put on the lid with cap. Put the
closed container with the ingredients on the driver unit.
Attaching and removing the dish (B, E)
Mount the bowl B or E on drive A2 so that it slides down, then secure it by turning it
clockwise tillyou hear a snapping sound (at the same time, safety lock is unlocked). Pay
special attention to this operation. You can remove the bowl in the opposite direction.
Switch (A1)
Start the drive by pushing the switch (the motor runs only for the time when the switch
is pushed). Push several times until you get the required result.
IV. USING THE BLENDER
The blender is perfectly for preparation fresh fruit drinks, fitness & protein drinks,
milkshakes, mixed alcoholic & non-alcoholic beverages, smoothies, but also for crushed
ice. Excellent for salsa sauces snack, etc., or to crush ice. After mounting of the assembled
blending bowl on the drive unit and after its filling with Ingredients.
Warning
Warning
21 / 47
GB
!
!