General Safety Instructions - Konig & Meyer 24615 Original Bedienungsanleitung

Safety instructions
The stand corresponds to the current state of the art and is equipped with the necessary safety
devices. It has been designed, built and documented in accordance with the applicable EU direc-
tives and the associated harmonised standards. This is certified by the declaration of conformity.
However, the stand may represent hazards if the safety and warning instructions in the operating
manual and the danger pictograms on the stand are not observed. The safety instructions in this
chapter will help you to avoid personal injury and damage to property.
The operator must ensure that all safety and warning instructions are understood and observed.

General safety instructions

u Do not use the stand if there is a visible damage or signs of wear.
u Protect the stand from weather effects. The stand is not designed for permanent outdoor use.
u The installation surface must have a level and solid base.
u Do not place the stand near escape routes or areas accessible to the public.
Warnings
Warning outlines
All warnings in this document are outlined as follows:
➀
1 Hazard pictogram
3 Nature and source of danger
5 Hazard prevention
➁ ➂
15
➄ ➃
2 Signal word
4 Possible consequences of misapplication