Elektrabregenz DKW 6565 X Bedienungsanleitung Seite 14

5 Installation of appliance
Hold the cooker hood by its body and place it on
the mounting screws on the wall and tighten the
screws (Figure 4).
Secure the cooker hood with two 4.8x50 screws to
the wall through the mounting hole on the interior
of the appliance (Figure 4).
WARNING: As the bends and el-
A
bows in the aluminium pipe will
cause a decrease in the air suction
power, using these must be avoided
as much as possible.
5.4 Connecting to Chimney
Figure 5
1. Flap Pin Socket
2. Flap Pin
Insert the plastic pin (Figure 5/area no. 2) on the
pin socket on the motor exhaust (Figure 5/area
no.1). Then bend the flap lightly to insert the other
pin on the flap and insert the other pin to its socket
(Figure 5).
If you are going to use the Ø 120/150 mm plastic
Chimney adapter, connect one end of the pipe to
this adapter, if you are not going to use it, to the
direct output on the product. Connect the other
end of the pipe to your chimney. Check that these
two connections are tight enough so they will not
come out when the appliance runs on full power.
14 / EN
Ensure that the flaps inside the Chimney work
when tightened with clamp. Connect the Chimney
connection duct outside the adapter (Figure 6/a).
If the connection duct is fitted inside the adapter,
suction of air shall not occur as the Chimney flap
that prevents the return of air will remain closed
(Figure 6/b). The length of the pipe connection as
well as the number of elbows must be as mini-
mum as possible.
A : Chimney exit pipe
B : Chimney Clamps
C: Plastic Chimney
The valves are closed then the appliance is not
operating and prevent possible outside odour and
dust from entering inside.
(a)
Ok
Figure 6
5.5 Installation of the Hood to the
Chimney
Make the electrical connection of your hood be-
fore starting the installation of the chimney. Slip
the Chimney plates around the body. Screw the
Chimney to the Chimney fastening plates availa-
ble on the motor cabin. (Figure 7).
Install the Chimney to the Chimney fastening plate
that is secured to the wall from its upper outer
edges (Figure 7).
Cooker Hood / User Manual
(b)
Not Ok