Elektrabregenz DKW 6565 X Bedienungsanleitung Seite 13

5 Installation of appliance
• Depth of drilling holes must comply with the
length of bolts.
• The bolts and dowels provided are suitable for
brick walls. For other construction material (e.g.
drywall, plate, porous concrete), suitable fixing
dowels and nuts shall be used.
Figure 2
CAUTION: Before drilling, ensure
A
that there are no power, gas or wa-
ter pipes in the close proximity of the
drilling locations.
• Draw a central point line on the wall, from the
ceiling to the lower side of the hood (Figure 2).
• There is a notch in the middle of the flue connec-
tion plate. Place the central point of this notch,
which is found on the flue connection plate, on
the vertical line you drew on the wall. Align it
vertically and use a pen to mark the holes to
which the flue connection plate will be installed
(Figure 2/a).
• Drill the marked points with a Ø6mm drill and
insert 2x Ø6mm plastic pins in these holes (Fig-
ure 2/a).
• Fix the flue connection plate to the wall with
3.9x22 screws (Figure 2/a).
• To drill hang holes for the hood, stick the in-
stallation template to the surface to which the
Cooker Hood / User Manual
product will be installed and mark the installa-
tion holes (Figure 2/b).
• Drill hang holes with Ø8mm drill and insert the
pins (Figure 2/b).
• Insert 2x4.8x50 hang screws, ensuring that
there is a 5 mm space between the screw head
and the wall (Figure 2/b).
Figure 3
1. Hanger Plate
2. Hanging Plate Connection Screw
• Loosen the connection screws to pull up the
hanging plates found on the body of the appli-
ance and then tighten the screws (Figure 3/a).
• Open the filter cover.
• Remove the metal oil filter.
• If the diameter of the air discharge pipe is
lower than 150 mm, install Ø150/120 mm flue
adapter.
Ø 4,8 x 50 mm
Figure 4
13 / EN