Program The Transmit - Commeo selve Transmit Betriebsanleitung

GB Program
5.

Program the transmit

...into a receiver or a drive
The simple assignment between transmitter and receiver is
described below. The description of the assignment of special
transmitters and / or multiple receivers, as well as the reset and
manufacture of the factory setting, is described in the operating
instructions of the respective products.
PROG button / SELECT button: Only operate with an insulated
tool (at least 1 kV voltage).
The end limits must already be set correctly.
step 1:
>1 s
step 2:
SELECT
3 s
the transmit
Disconnect the mains voltage of the receiver or actuator
for at least 1 second and then switch it on again.
The receiver / drive can be found in the next 4 minutes
from the commeo Transmit
Switch on SELECT mode: Press SELECT button for 3
seconds.
The commeo Transmit "searches" the previously
activated receiver or drive
The assignment is indicated by a short jogging of the
system
20