Connecting Switch And Push Button - Commeo selve Transmit Betriebsanleitung

Installation / Connection
4.5.

Connecting switch and push button

a) input in 1 : Only connect a switch
• Drive immediately starts in the selected direction and will stop at the
setted limits.
• Set the switch to the neutral position during travel: the drive stops
immediately.
• Application/ used for: e.g. For blinds / Venetian blinds, in order to adjust
the slat angle individually
b) input in 2 : Only connect a push button
− Press push button for 1 second:
The drive starts with a delay into the selected direction. After releasing
the pressed pushbutton, it returns to the zero position, and ...
• The drive continues to te setted limits OR
• The drive can be individually stopped by a short pushing in UP or in the
DOWN direction
Set the intermediate position 1 and 2 by using a hand or a wall
transmitter
− Press the button 2 x briefly in the OPEN direction
• Drive moves to intermediate position 1
− Press the button 2 x briefly in the CLOSE direction
• Drive moves to intermediate position 2
19
GB