Lehner Versand ZHQ2566-RMLED-W Bedienungsanleitung Seite 19

Minimum required distances:
a) 50cm from the side wall
b) 30cm from the ceiling
c) Installation height above 180cm
Follow the below steps to install the heater:
Step 1: Drill 4 holes in the wall as shown in the size
Step 2:Take off the nuts, the spring locks washers and the plain washers from four
explosive bolts. Keep them for the next step.
Step 3:Installer the heater on the wall， then Adjust the product to a suitable position and
tighten the positioning screw by hand
OPERATING INSTRUCTIONS
WANRING: The heater must be properly installed before it is used This unit is equipped with
one heat setting On I Off.

Plug the Patio Heater into a grounded 220-240V 50-60Hz power outlet.

Press on the On/Off switch to the "I" position to activate the heater.
Touch switch
Press " " the first time:
Switch on the heating tube on the left side of the product.
Press " " the second time:
Switch on the heating tube on the right side of the product.
The heating element on left side turns off.
Press " " for the third time:
The two heating tubes of the product will work at the same time.
Press " " for the fourth time:
2 heating tubes switched on, and LED lights working at the same time.
Press " " for the fifth time:
Both heating elements are turned off, and the LED light is working alone.
Press " " for the sixth time, and the product enters into the standby state.
4