Description Of The Device; Start Up - Shx Shx20Skv2001 Bedienungsanleitung

Function switches
Thermostat
The installation and operation of the SHX fan heater is very quick and uncomplicated:
1. Remove the heater from the packaging and remove all the packaging materials.
2. Check the device for possible damage.
3. Unwind the power cord and also check it for damage.
4. Install the feet as follows:
1. Turn the device upside down.
2. Install the feet with the screws.
5. Turn the device back up.
6. Place the device on a stable, flat surface that is insensitive to heat.
7. Make sure that the switches are "OFF" and the thermostat is at "MIN", before operating.
8. Insert the plug into a suitable socket.
9. To turn on the device, proceed as follows:
1. Turn the thermostat to "MAX" (clockwise), to set the highest possible
temperature.
2. Press one of the switches to set the desired heating level:

750W

1250W

To achieve the maximum output of 2000W, press both switches.
10. When the desired temperature has been reached, turn the thermostat anticlockwise
until the lights on the switches turn off.
11. The device then keeps the temperature at the set temperature by switching on and off
automatically.
12. To turn the device off completely, turn the thermostat anticlockwise to "MIN" and
press all switches.

DESCRIPTION OF THE DEVICE

START UP

 low heating with 750W
 mid heating with 1250W
Seite 14 von 18
Feet
Air Outlet