Disposal Of The Device; Declaration Of Conformity - Battery Controller X-PRO 36 Benutzerhandbuch

Connect BC X-PRO 36 to the vehicle to be powered, making sure to firmly connect the red terminal to the
end of the eyelet connector connected to the positive pole of the battery and the black terminal to the
chassis (or to the end of the eyelet connector connected to the negative pole of the battery).
Make sure the connection is stable and secure and that the power supply status is "ON" before
disconnecting the battery from the vehicle, to avoid data loss. Proceed replacing the battery with correct
polarity and making sure that the terminals of BC X-PRO 36 do not disconnect from the vehicle.
Once the new battery is installed, press the "ON/OFF - SELECT" button to stop providing the power supply
and then disconnect the terminals from the vehicle.
PROTECTIONS
BC X-PRO 36 is able to provide the operator with the following set of active protections during installation
and use, while working in Battery Charger mode:
1. Protection against battery poles inversion.
2. Protection against short circuit (even for an indefinite time): no sparks!
3. Protection against overheating: the supplied current is automatically limited in case of excessive heating
of the device.
It is recommended to pay particular attention when connecting to a vehicle in Power Supply mode: a
polarity inversion or a short circuit could generate sparks and damage the vehicle's electronics.
BC X-PRO 36 is provided with an internal protection fuse against connection mistakes by the user.
.
MAINTENANCE

If the power cable is damaged, do not use the product but ask for replacement or repair by the
manufacturer or by an authorized service center.

Before executing any cleaning/maintenance operation on the device, please check the device is not
connected to the power outlet.

The battery charger is designed not to require any maintenance: please remove possible dust
which may get accumulated on the cover of the device using a delicate detergent to avoid
damaging the stickers. In case the device does not work properly, do not attempt to repair it;
please ask either your local dealer or the equipment manufacturer (info@batterycontroller.it) for
support. Any attempt to open unduly the device shall cause the withdrawal of the warranty.

If the internal fuse is damaged, please ask the device manufacturer or an authorized service center
for replacement.

DISPOSAL OF THE DEVICE

The device must be disposed of in accordance with the WEEE regulation for the disposal of Waste Electrical
and Electronic Equipment. Do not dispose of it with normal household waste.

DECLARATION OF CONFORMITY

The device is manufactured in compliance with current safety regulations and European Directives.
Forelettronica Srl declares under its own responsibility that the BC X-PRO device complies with the
following standards. Reference standards: 60335-1, 60335-2-29, 55014-1, 55014-2, 61000-3-2, 61000-3-3,
62233, 50581.
The device is CE marked. The declaration of conformity can be downloaded from our website.