Battery Controller X-PRO 36 Benutzerhandbuch Seite 17

START / STOP THE CHARGE:
Once the desired charging parameters have been selected, connect BC X-PRO 36 to the battery to be
recharged (red terminal: positive pole - black terminal: negative pole), following the instructions reported
in the paragraph: "Connection of BC X-PRO 36" and press the "ON/OFF - SELECT" button to start charging.
At any time, it is possible to stop and restart the charging procedure by pressing the "ON/OFF - SELECT"
button.
During charging, the display shows the following indications:

Row 1: the selected charging parameters (battery type and maximum current)

Row 2: SHOWROOM Mode ON/OFF

Row 3: the current supplied by the battery charger and the battery voltage (state of charge)

Riga 4: the ampere-hours delivered to the battery and the time elapsed since the beginning of the
charging process
The display also shows any error or anomaly (load not connected, polarity inversion or short circuit, mains
not connected...).
Once charging is complete, the charger automatically keeps the battery at an optimal voltage. It is
recommended to reduce the vehicle's absorption to a minimum, turning off any superfluous loads during
charging.
SELECTION OF SAFETY PARAMETERS FOR CHARGING
It is possible to select several customized additional
settings for the Battery Charger operating mode by
following the procedure below:
1. Press and hold the "ON/OFF - SELECT" button for 5
seconds to access the menu.
2. Press the arrow keys until you reach Menu: SAFETY.
Press "ON/OFF - SELECT" to confirm.
3. Select Battery Test ON/OFF to choose whether to
execute the battery cells check at the end of the
Recovery, Soft Charge and Bulk Charge cycles. Press
the "ON/OFF - SELECT" button to confirm the
choice.
4. Set the maximum Ah value to supply to the battery
(optional), from 1 to 999 Ah. Hold the arrow key
pushed to increase/decrease quickly the value. The
standard setting of the device does not provide for
a maximum limit of Ah. To disable the limit, press
the arrow button ↓ until you reach OFF. Press the
"ON/OFF - SELECT" button to confirm the choice.
5. Set the maximum time for battery charging
(optional), from 1 to 999 ore (h). Hold the arrow key
pushed to increase/decrease quickly the value. The
standard setting of the device does not provide for
a maximum charging time. To disable the limit,
press the arrow button ↓ until you reach OFF. Press
the "ON/OFF - SELECT" button to confirm the
choice.
The safety parameters set in this way are saved in
memory for subsequent uses.