Maintenance, Inspection, Repair; Disposal - Matrix Vision BVS CA-SF2-Serie Betriebsanleitung

BVS CA - SF2 - _ _ _ _ _ _ - _ _ _ _ _ _ - XAS2
2 SAFETY
2.2.4 Maintenance, in-
spection, repair
2.3

Disposal

www.matrix-vision.com www. matrix-vision.com
The working principle used in this BVS Industrial Camera is maintenance- and wear-free.
The operator must regularly inspect the BVS Industrial Camera for signs of damage or
malfunctions in line with the operating conditions and environmental influences. If any
damage or wear is found, the BVS Industrial Camera must be immediately taken out of
operation and secured against unauthorized use.
Only service technicians from Balluff GmbH may repair defective devices. Intervention in
the product by the operator is not permitted due to safety reasons. The BVS Industrial
Camera's housing may not be opened or loosened!
WARNING
Before maintenance, disconnect the device from the power supply.
f_
NOTE
In the interests of product improvement, MATRIX VISION GmbH
reserves the right to change the technical data of the product and
the content of this manual at any time without notice.
Observe the national regulations for disposal.
8