Attention! Only the end of the hook (13) is attached to the operating
lever (12) by means of the bearing pin (20b).
Attention! Risk of a limb injury
Lift again the the operating handle (12) drawing the hook (13) upwards to
10)
make the second bearing pin (20b) visible;
11)
Remove the second bearing pin (20b) and the hook (13) (see chapter 7
DISPOSAL, page 30/32) keeping the operating handle (12);
Clean carefully all the removed
N
pins, the inner side of the tie-rod
O
(3) and the bearings still in their
T
E
seats.
Before mounting the hook (13) it is important to verify if the pivot pin
N
(19), the bearing pins (20a and 20b) with the bearings (22 and 23)
O
and the operating handle (12) have to be replaced (see chapter 5.5
T
REPLACEMENT OF THE BEARINGS AND THE PINS, page 27/32 and/or
E
chapter 5.6 REPLACEMENT OF THE OPERATING HANDLE, page 28/32).
HOOK COUPLING UN 76
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
20b
3
13
PAG.
25/32
CHAP . 5
REV. 00
12
20b