Safety Instructions - Bestway P5535 Benutzerhandbuch

SAFETY INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS - READ AND FOLLOW ALL INSTRUCTIONS.
Warning - Do not connect the chain to supply while it is in the packing or wound onto a reel.
Do not use the chain when covered or recessed into a surface. Do not open or cut the chain.
The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged,
the luminaire shall be destroyed. The light source of this luminaire is not replaceable; when the
light source reaches its end of life the whole luminaire shall be replaced.
Do not connect this chain electrically to another chain. The lamps are not replaceable.
SAVE THESE INSTRUCTIONS.
IMPORTANT: Do not put the
Remote Control in the water, if the
remote control falls into water,
take it out of the water
immediately.
Damage to the remote control
caused by immersion in the water
is not covered under your
warranty.
Battery Precaution
• Do not mix old and new batteries.
• Do not mix the different types of batteries. Do not mix alkaline, standard (Carbon - Zinc), or rechargeable
(Nickel - Cadmium) batteries.
• Ensure batteries are installed correctly with regard to polarity (+ and -).
• Do not short-circuit the battery.
• Never attempt to recharge primary batteries as this may cause leakage, fire, or explosion.
• Rechargeable batteries are to be removed from this product before being charged.
• Never attempt to disassemble or open batteries as this can lead to electrolyte burns.
• Remove batteries from equipment which is not to be used for an extended period of time.
• Exhausted batteries are to be removed from this product.
• Do not dispose of product and its batteries in fire. Check your local regulations for proper disposal instructions.
• Batteries shall not be exposed to excessive heat such as sunshine, fire or the similar.
• Keep batteries out of the reach of children.
• Only use 2x CR2032 batteries.
Parts reference overview
LED strip, 433.92MHz
LED Remote Control, 433.92MHz, -10dBm
DC output transformer. Output:12VDC,1A
Follow the instructions to straighten the strip before installing to the SPA.
ATTENTION: DO NOT TWIST OR THE STRIP COULD BREAK
ATTENTION: DO NOT PULL THE STRIP FROM THE CONNECTION
WARNING: THIS ROPE LIGHT MUST NOT BE USED WITHOUT ALL GASKETS BEING IN PLACE.
LED Strip
Owner's Manual
Model P5535
WARNING
(Auto-off in 2 hours)
Manual Color Change
Software Version:
CPU-SOP8-64A8/B637 for LED strip
CPU-SOP14-3F2A(8586) for Remote Control
4
ON/OFF
Flash Rate
Auto Color Change
Brightness Adjustment