Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating instructions
Surge protected 6 socket power strip,
switchable
Item no. 1296314
Intended use
With this power strip you can protect your electronic devices from power surge damage. The
surge protection indicator lamp comes on and indicates that the connected device is protected
from power surge in the mains network. All connected devices can be disconnected from the
mains using the lit ON/OFF switch. This power strip also has a separate ON/OFF switch for
the individual sockets. The product is only allowed to be used in dry, closed rooms indoors.
For safety and approval purposes, you must not rebuild and/or modify this product.
If you use the product for purposes other than those described above, the product
may be damaged. In addition, improper use can cause hazards such as short circuit-
ing, fire, electric shock etc. Read the instructions carefully and keep them. Make this
product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Power strip
• Operating instructions
Up-to-date operating instructions
Download the up-to-date operating instructions at www.conrad.com/down-
loads or scan the QR code shown. Follow the instructions on the website.
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any result-
ing personal injury or damage to property. Such cases will invalidate the
warranty/guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed if
the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
• The product is equipped with a protection against accidental contact. An inte-
grated mechanism will release the holes of the receptacle only, if the two prongs
of a power plug are inserted into the two holes at once.
• Take special caution when children are around. Children cannot recognize the
danger arising from the incorrect use of electrical devices. There is a risk of a
life-threatening electric shock!
• As a source of voltage, ensure that you only use a proper mains socket (230 V/
AC, 50 Hz) of the mains power supply.
• The mains outlet must be located near to the device and be easily accessible.
• Fully unwind the power cable during operation. The power cable is not al-
lowed to be squashed or damaged by sharp edges. Do not place any
objects on the power cable and do not step on it. Lay the power cable
in such a way that no-one can trip over it and so that the plug is easily
accessible. Do not lay the cable for example under carpet.
• The product is not to be touched, operated or switched on/off with damp or wet
hands. Danger of life due to electric shock!
• Never connect the product straight away to the power supply, if it is taken
from a cold room to a warm room (e.g. after transportation). The conden-
sation this creates could destroy the device or cause an electric shock!
First let the product reach room temperature. Wait until the condensa-
tion has evaporated, which can take a few hours. Only then is the product
allowed to be connected to the power supply and operated.
• Always ensure you only pull on a plug by the intended handling areas and never
pull the plug out of a socket by its cable.
• Do not overload the power strip. Observe the power rating indicated in the chapter
"Technical data".
• Do not connect two power strips together! This can cause the power strip
to become overloaded. Danger of fire! Insert the grounded mains plug
of the power strip directly, for example, into a wall power point. Do not
connect any more power strips to the power strip.
• Do not use the power strip if it is covered! In the event of a higher power rating the
power strip and the connecting cable heat up, which can lead to overheating and
even fire if covered.
• The power strip is only de-energised if the plug is removed from the power point.
• The plug must be removed from the power point in the following conditions:
- before cleaning the products
- if the product is not used for a longer period of time.
• D o not pour fluids over or next to the product. There is a high risk of fire or life-
endangering electric shock. If fluid still manages to get inside the device, perform
an all-pole disconnection of mains power socket to which the power strip is con-
nected. (Switch off the fuse/automatic circuit breaker/earth leakage circuit breaker
of the respective circuit. Only then should you remove the plug of the power strip
from the mains power point and contact a specialist. Do not use the product any
more.
• In commercial premises observe the accident prevention regulations of the as-
sociation for commercial trade associations for electrical systems and equipment.
• In schools, centres of education, hobby and self-help workshops, the use of this
product with electrical devices must be monitored by trained personnel.
• Consult an expert when in doubt about operation, safety or connection of the
device.
• M aintenance, modifications and r epairs are to be performed exclusively by an
expert or at a qualified shop.
• If you have questions which remain unanswered by these operating
instructions, contact our technical support service or other technical
personnel.
Werbung
