Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating instructions
19" (48 cm) rack-mount power strip (8 sockets)
Item no. 1517030
Intended use
This socket strip provides eight mains sockets with protective earth contacts. All of the sockets
can be turned on or off together using the on/off switch, which features a built-in light.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in
bathrooms, must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use
the product for purposes other than those described above, the product may be damaged.
In addition, improper use can cause hazards such as short circuiting, fire, electric shock etc.
Read the instructions carefully and keep them. Make this product available to third parties only
together with its operating instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Power strip
• Operating instructions
Up-to-date Operating Instructions
Download the latest operating instructions at www.conrad.com/downloads or scan the QR code
on this page. Follow the instructions on the website.
Explanation of symbols
The symbol with the lightning in the triangle is used if there is a risk to your health,
e.g. due to an electric shock.
The symbol with the exclamation mark in the triangle is used to indicate important
information in these operating instructions. Always read this information carefully.
The arrow symbol indicates special information and advice on operation.
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the warranty/
guarantee.
a) General information
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed
if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
• Consult an expert when in doubt about operation, safety or connection of the
device.
• Maintenance, modifications and repairs are to be performed exclusively by an
expert or at a qualified shop.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
b) Electrical safety
• Before connecting to the mains, make sure that your local AC mains voltage
matches the specifications on the nameplate.
• This product is built according to protection class I. It must only be connected to a
mains socket with a protective earth contact.
• Never pour any liquids over electrical devices or put objects filled with liquid
right next to the device. If liquid or an object enters the interior of the device
nevertheless, first power down the respective socket (e.g. switch off circuit
breaker) and then pull the mains plug from the mains socket. Discontinue use and
take the product to a specialist repair centre.
• Never use the product immediately after it has been brought from a cold room into
a warm one. The condensation generated could destroy the product. Allow the
product to reach room temperature before connecting it to the power supply and
putting it to use. This may take several hours.
• The mains outlet must be located near to the device and be easily accessible.
• Never pull the mains plug from the socket by pulling at the cable. Always pull it
from the mains socket using the intended grips.
• Unplug the mains plug from the mains socket if you do not use the device for an
extended period of time.
• Disconnect the mains plug from the mains socket in thunderstorms for reasons
of safety.
• Make sure that the mains cable is not squeezed, bent, damaged by sharp edges
or put under mechanical stress. Avoid excessive thermal stress on the mains
cable from extreme heat or cold. Do not modify the mains cable. Otherwise the
mains cable may be damaged. A damaged mains cable can cause a deadly
electric shock.
• Do not touch the mains cable if it is damaged. First, power down the respective
mains socket (e.g. via the respective circuit breaker) and then carefully pull the
mains plug from the mains socket. Never use the product if the mains cable is
damaged.
• A damaged mains cable may only be replaced by the manufacturer, a workshop
commissioned by the manufacturer or a similarly qualified person, so as to prevent
any danger.
• Never plug in or unplug the mains plug when your hands are wet.
• Each socket features a child safety lock. The socket can only be unlocked by
inserting the pins of a plug into both of the socket openings at the same time.
However, you should still exercise particular caution when children are present.
Children may be unaware of the hazards resulting from the incorrect handling of
electrical devices. Handling the product incorrectly may cause a fatal electrical
shock!
• Do not overload the socket strip. Refer to the maximum total power consumption
of all connected loads in the "Technical data" section.
• Insert the mains plug on the socket strip into a wall socket.
• Do not connect the product in series! Do not connect any other socket strips or
other power distribution devices to the product. This may lead to an overload,
which constitutes a fire hazard!
• Do not use the power strip when it is covered. The power strip and the connection
cable will become warm when there is a high connected load. This presents a
fire hazard.
• The plug is only isolated from the mains when it is disconnected from the mains
socket.
• Only use the product in temperate climates. It is not suitable for use in tropical
areas.
Before installation
• Keep the product out of the reach of children.
• Only secure the product to a stable surface. Depending on the surface, screws and/or dowels
must be used.
Ensure that no existing cables or pipes (including water pipes) are damaged when
drilling holes or securing screws.
Werbung
