ZEEGREZ Z.RILL 47003001 Montageanleitung Seite 8

47003001
47007001
47004001
47002001
1
3
1. Fill the gap between the wall and the outlet hole with silicone. Turn on the valve and allow the water to
run freely for 5 minutes. Then turn off the valve.
2. Enlace the bended connector with adhesive tapes. Then twist it into the outlet hole.
3. Adjust the position of the two bended connectors to be horizontal, and make sure the center distance
to be 150mm.
4. Twist the decorating board into the bended connector,Put the flat washer into the connecting nut.Twist
the connecting nut into the bended connector. Then use the spanner to fix it firmly.
8
Installation
MIXER BODY
INLET HOSE
HOSE
O-RING
RUBBER WASHER
BRASS WASHER
FEMALE SCREW
HEAD SCREW
1. Fit the O-ring in the underside of the mixer
body.
2. Screw the flexible hoses into the mixer body,
and fully hand tighten.
3. Pass the tail of flexible pipes through the hole
on the basin from above, and place the mixer in
position on the basin, to see if any alteration to the
existing supply pipe work is necessary, make any
necessary alterations to the pipe work.
4. Tighten the rubber washer, the brass washer
with the female screw from the under-side of the
counter.
5. Check that the mixer body is correctly
positioned, fully tighten the female screw.
6. Connect the water supply pipes to the tail of
flexible hoses with the hot water and cold water.
2
BENDED CONNECTOR
4
FLAT WASHER
FEMALE SCREW