PRONIVO PNHLR G Bedienungsanleitung Seite 21

Power Supply
Usage of rechargeable Li-Ion batteries:
Please pay attention to the safety notes for batteries and chargers.
1. Before the first usage, the Li-Ion battery needs to be charged for se-
veral hours.
2. Put the charger cable in the charger plug of the instrument.
3. Put the other end of the charger cable in the power plug (110
or 220V).
4. The rechargeable battery and the charger can be damaged if they fall
down. Please store both items at a dry location.
If the battery is fully charged, the battery LED is green. If the battery
is nearly discharged, the battery LED is red. In this case, recharge the
battery. During the charging process, the LED close to the battery
compartment is red.
Remove the battery from the unit if you do not use it for a longer time
period. There is risk of corrosion and discharge. If the operating time
is low despite of fully charged batteries, the battery pack must be re-
placed. Please contact your dealer. If you did not purchase the instru-
ment from a dealer, please contact proNIVO Messgeräte Handels GmbH.
Alternative also Alkaline batteries can be used
Use four C batteries and insert them in the battery compartment. Pay
attention to the battery symbols. Do not short-circuit the batteries. Do
not load non-rechargeable batteries. This can result in fire hazard.