Technical Speci Cations; Battery Warning - IconBiT K8 Bedienungsanleitung

3. How to use the Boardcomputer

4. Technical speci cations

► Frame:
Aluminum Alloy
► Battery type:
10 Ah Lithium battery
► Motor:
36 V 250 W brushless motor
5. Battery

BATTERY WARNING

• Failure to follow the Safety Precautions listed in this Battery Warning could lead to serious bodily
injury and death. Seek immediate medical attention if you are exposed to any substance that is
emitted from the battery.
• Do not touch any leaking materials, or breathe fumes emitted. Do not allow children and animals
to touch the battery.
• The battery contains dangerous substances, do not open the battery, or insert anything into the battery.
• Please only use the charger provided with this E-Bike.
• Do not attempt to charge the E-Bike if the battery has discharged or emitted any substances.
In that case, the battery should be abandoned for safety.
• Please follow all local, state and federal laws in regards to recycling, handling and disposing of Lithium Ion batteries.
Danger of short circuit, re and explosion!
• Use only the enclosed rechargeable battery for this E-bike!
• A rechargeable battery with damaged housing must no longer be used. Replace the rechargeable battery!
• Never open or repair the rechargeable battery. Replace the rechargeable battery instead if it is defective.
• Keep the rechargeable battery away from fire and excessive heat.
• Never hold the rechargeable battery under water. Never clean it with a high-pressure cleaner!
• Never expose the rechargeable battery to any intense impacts or permanent vibrations!
• Ensure safe storage when transporting it e.g. in a car.
• If transporting the E-bike by car carrier system take out the rechargeable battery.
HOW TO CHARGE THE BATTERY
Step 1: Ensure that the charging port is clean and dry. Make sure that there is no dust, debris or dirt inside the charging port.
Step 2: Plug the charger into the wall, then connect the cable with the power supply (100V ~ 240V; 50, 60 Hz), make sure the light
on the charger is lit GREEN.
Step 3: Connect the charging cable into the charging port of the E-Bike. The indicator light on the charger should change to RED,
indicating that your E-Bike is now being charged. When the RED indicator light on your charger turns to GREEN, then your
E-Bike is fully charged. A full charge typically occurs within 2-3 hours.
Step 4: Please unplug the charger from your E-Bike and from the power outlet.
Charge the rechargeable battery completely again if possible after every ride. This type of rechargeable battery does not su er any memory
e ect. For the charging times of your E-Bike, see the technical data. You can charge the rechargeable battery in or outside of the E-Bike.
English 2/6
3.1. TURN ON/OFF
Press and hold the power button (M)
to start the device.
3.2. BATTERY
The Power indicator (5 levels) shows
the remaining capacity
of your battery.
100-80%
80-60%
60-40%
40-20%
0-20 %
► Max. speed:
25 km/h (assistant mode)
► Tire style:
27.5'' in atable tire
► Braking system:
Double disc brake
3.3. GEAR SHIFT
The gear can be toggled from low to high by pressing on "+" or "-".
Each gear setting will give a di erent level of acceleration and
maximum speed (low, mid, high).
► Waterproof grade:
IP54
► Maximum weight:
100 kg
Battery Speci cations
Battery Lithium Battery
Charging time 2-3h
Voltage 36V
Initial Capacity 10Ah
Working Temperature 0°C ~ +50°C
0°C ~ +35°C
Charging Temperature
Storage Time 12 months
Storage Temperature 0°C ~ +25°
Storage Humidity 5%-95%