Ribimex Ribitech PRBAT20/CC4 Bedienungs- Und Wartungsanleitung Seite 18

(C) Safety information about the charger and the battery-pack
Before using the charger and the battery, read all the instructions and cautionary markings on charger,
battery pack and tool.
1) Charger
a) Do not attempt to open or disassemble the charger. If the charger has been dropped or is
damaged in any way, stop using it and do not attempt to repair it. Return the charger for repair to an
authorized service center or a qualified person, to avoid any danger to the user; or discard it according to
local laws.
b) Protect the charger against any heat source (e.g. direct sunlight exposure, fire, heater...). To
prevent any damage to the charger.
c) Do not expose the charger to water, moisture and cold. Electric shock hazard.
d) If the power cord or the plug becomes damaged, stop suing the charger until it has been repaired
by a qualified person. If the supply cord is damaged, it must be replaced by the
manufacturer or its authorized service center, in order to avoid a hazard. Electric shock hazard.
e) Only use the charger provided with the tool, or a same type or same model charger to charge the
battery. The use of other types of charger increases the risk of electric shock, personal injury and
damage.
f) Never attempt to recharge non-rechargeable batteries. Batteries may explode
g) Only use the charge at ambient temperatures between +10°C and +40°C. Store charger in a dry
location protected from cold where temperature would not exceed +40°C. To prevent any damage to the
charger.
h) The charger is intended for indoor use only. Place charger on solid, flat non-flammable surface
and away from any flammable materials when re-charging the battery pack.
Do not recharge the battery pack in a wet or humid environment. The charger and battery pack may
heat during charging process.
2) Battery
a) Do not attempt to open the battery. If the battery is damaged in any way, stop using it and do not
attempt to recharge it. Short-circuit or electric shock or explosion hazard. Discard it according to local
laws.
b) Protect the battery pack against any heat source (e.g. direct sunlight exposure, fire, heater...). To
prevent any damage or explosion hazard.
c) Do not expose the battery pack to water, moisture and cold. To prevent any damage.
d) In case of damage and improper use of the battery, vapours may be released. Ensure proper
ventilation and provide for fresh air to the work area. The vapours can irritate the respiratory system.
e) Only use the battery pack provided with the tool. The use of other types of batteries may increases
the risk of electric shock, personal injury and damage.
f) Use only original batteries or recommended by the manufacturer with the voltage matching your
tool, as listed on the nameplate. When using other batteries (e.g. reconditioned batteries or other
brands), there is risk of explosion causing injury or property damage.
g) Charge battery pack only at ambient temperatures between +10°C and +40°C. Store the battery in
a dry location protected from cold where temperature would not exceed +40°C. To prevent any damage
to the battery.
h) Do not store or carry a battery in a pocket, toolbox or any other place where it may come into contact
with metal objects. The battery pack terminals may be short-circuited causing damage to the battery or burns
or a fire. Make sure that no conductive material touches the terminals.
Page 18 / 57