Atlantis A03-X1000 Handbuch Seite 19

ENG
Copyright
The Atlantis logo is a registered trademark of Atlantis. All other names mentioned
mat be trademarks or registered trademarks of their respective owners. Subject to
change without notice. No liability for technical errors and/or omissions.
IMPORTANT SAFETY INSTRUCTIONS
This manual contains important safety instructions. Please follow all instructions
carefully during installation. Read this manual thoroughly before attempting to
unpack, install or operate.
Caution: Any changes or modifications to the equipment not expressly approved by
the party responsible for compliance could void the user's authority to operate the
equipment.
Shielded interface cables and AC power cords, if any, must be used in order to comply
with the emission limits.
Caution: To prevent the risk of fire or electric shock, install in a temperature and
humidity controlled indoor area, free of conductive contaminants.
Caution: Risk of electric shock, do not remove the cover. No user serviceable parts.
The UPS system operates with hazardous voltages. Repairs may be carried out only
by qualified maintenance personnel.
Caution: Connect the UPS system only to an earthed shockproof outlet which must
be easily accessible and close to the UPS system.
Caution: Risk of electric shock, hazardous live parts inside this UPS can be energized
from the battery supply even when the input AC power is disconnected.
Caution: Risk of electric shock, Battery Circuit is not isolated from AC input,
hazardous voltage may exist between battery terminals and ground. Test before
touching.
Caution: Do not install the UPS system near water or in moist environments.
Caution: Do not install the UPS system where it would be exposed to direct sunlight
or near heater.
Caution: Do not block ventilation holes in the UPS housing.
Caution: The UPS is designed to be for use with computer loads only. Do not connect
a laser printer to the outlets. Do not connect domestic appliances such as hair dryers
to UPS output sockets.
Caution: Please use only CE-marked mains cable (e.g. the mains cable of your
computer) to connect the UPS system to the building wiring outlet (shockproof
outlet).
Caution: Please use only CE-marked power cables to connect the loads to the UPS
system.
Caution: Prevent no fluids or other foreign objects from inside of the UPS system.
19