Troubleshooting - Femi XXX Gebrauchsanleitungen Und Wartung

6.3 DISPOSAL OF THE MACHINE, PACKING
At the end of the machine life, if the
machine must be scraped, contact
an authorised waste disposal centre
in order to comply with the Standards
for hygiene and environment
safeguard.
7

TROUBLESHOOTING

PROBLEMS
The motor does not run
The motor starts slowly
and does not reach
running speed
Excessive motor noise
The motor does not
reach full power
The motor tends to
overheat
Decrease in cutting
capacity
The cutting finish is
irregular or uneven
Flaking of the workpiece
18
2002/96/EC
CAUSES
Faulty motor, power supply
cable or plug.
Burned out fuses
Low power supply voltage.
Damaged windings. Burned out
capacitor
Damaged windings. Faulty motor
Overloaded circuit due to
lighting, utilities or other motors
Overloaded motor. Insufficient
motor cooling
The blade has been repeatedly
sharpened and its diameter has
decreased
The blade is worn out or the teeth
are not suited to the thickness
of the material being cut
The blade's teeth are not suited
to the workpiece
The packing must be disposed of according to the ruling
standards by delivering it to authorised people for the
collection, disposal or reclaim.
Please contact the ASSOCIATION OF USED OILS near to
you.
SOLUTIONS SUGGESTED
Have the machine checked by skilled personnel.
Do not try to repair the machine yourselves as it
may be dangerous.
Check the fuses and replace them if necessary.
Ask for the Electricity Board to check the voltage
available.
Have the machine motor checked by skilled
personnel.
Have the capacitor replaced by skilled personnel.
Have the motor checked by skilled personnel
Do not use other utilities or motors on the circuit
to which the cutting-off machine is connected
Avoid overloading the motor during cutting.
Remove dust from the motor in order to allow
adequate cooling.
Adjust the limit switch for the lowering of the
head.
Have the blade sharpened by skilled personnel.
Check that the blade being used is appropriate
by refering to the paragraph 'SELECTION OF
THE BLADE'.
Check the appropriate teeth to use by refering to
the paragraph 'SELECTION OF THE BLADE'