Accessories; Regular Maintenance - Femi XXX Gebrauchsanleitungen Und Wartung

5

ACCESSORIES

5.1 SELECTION OF THE BLADE
The mitre-saw is fitted with a WIDIA blade (305 diameter
x 30 hole x 2,5 thickness mm.).
The following blades are available:
Blade D.305 mm. 48 Teeth
Blade D.305 mm. 72 Teeth
Blade D.305 mm. 96 Teeth
Blade D.305mm. 96 Teeth for alluminium
5.2 ASSEMBLY AND ADJUSTMENT OF THE
VERTICAL CLAMP (Fig. 13)
CAUTION: When cutting bars or pieces of
aluminium or plastic, use of the clamp is
advisable to hold the piece firmly against the
angular bearings, thus avoiding movement
during cutting and, therefore, jams which could
damage both the workpiece and the blade.
- Insert the pin 49 in the hole provided 50 and lock it with
the knob 51.
- Insert the clamp 52 on the pin 49 and lock it at the
desired height with the knob 54.
- Screw the upper knob 53 to lock the piece to be cut.
To cut domestic and exotic,
hard and soft
To cut chipboards and
laminates to a maximum 30
mm
To cut frames
To cut alluminium and plastics
5.3 SUCTION OF DUST RESIDUES
(Fig.14) (OPTIONAL)
The mitre-saw can be connected to an aspirator or a dust
collection bag can be mounted by means of the exhaust
manifold 13.
The aspirator pipe or the bag sleeve must be secured to
the manifold by means of a band. Users are reminded to
empty the bag or aspirator container and to clean the filter
regularly.
The air output speed must be equivalent to at least 100
Nm 3 /h.
For example, "dustbin" type aspirators are suitable.
6 MAINTENANCE
6.1

REGULAR MAINTENANCE

The regular maintenance decribed above and in the
paragraph below can be carried out by unskilled personnel.
1. Do not oil the mitre-saw, cause cutting must be carried
out in dry conditions (including the cutting of aluminium
and aluminium alloys); all rotating parts are self-
lubricating.
2. During maintenance, wear protective gear if possible
(accident-prevention goggles and gloves).
3. Remove cuttings when necessary both from the cutting
area, work surfaces and support bases.
Use of an aspirator or brush is recommended.
HAZARD: Do not use compressed air jets!
4. Regularly check blade conditions: if difficulties should
arise during cutting, have it sharpened by skilled
personnel or replace it if necessary.
5. Periodically, check that the blade comes to a complete
standstill within 10 seconds of releasing the button,
and that the arm's spring allows the arm to return back
up to its mechanical stop within 2 seconds; in the
event of either of these test returning a negative
outcome, get your machine serviced by an authorized
technician.
6.2 ASSISTENCE
When in need of skilled personnel for special maintenance,
or for repairs, both during and following the guarantee
period, always apply to authorized centres for assistance
or directly to the manufacturer if there is no authorized
centre in your area.
17