KURIS BOM 30 Bedienungsanleitung Seite 5

Spezialmaschinen GmbH
Important!
Read the Operating Instructions before starting to use your new KURIS miniature trimming
machine.
Application:
Particularly light and handy machine for cutting textiles of every kind up to a layer thickness of
approx.
27 mm, depending on the type of fabric concerned. Particularly suitable for wool and soft fabrics.
The felt oiler reduces friction between the cutter and countercutter so that laminated materials can
also be cut.
Technical data:
Motor power consumption
Motor speed (idling)
Cutter speed (idling)
Cutter diameter
Cutter wear limit
Cutting height, max.
Machine weight without cable
Vibration
Running noise
Machine designed to VDE 0740, protection class I and fully insulated, as well as to EC Directive.
Interference suppressed as per VDE 0875.
Start-up:
The machine may only be connected to a power supply with the voltage specified on the rating
plate.
IMPORTANT: The machine must be switched off before inserting the plug in the socket
outlet!
Operation of the machine, safety instructions: (Fig. 1)
Set the cutter guard to the material thickness. Switch on rocker switch to start motor. Guide
machine against the material to be cut, slightly raise the material and start cutting. When cutting,
ensure that your hand always rests on the material beside the cutter and never in front of the
cutter Ensure that the power cable is well away from the cutting contour in order to reduce the risk
of cutting through the cable. For safety reasons, switch off when the material has been cut and
close the cutter guard to avoid accidental contact with the cutter. The number of layers to be cut
depends on the thickness of the material. The motor speed must not drop too low otherwise it will
overheat.
Resharpening the cutter: (Fig. 2)
Switch on motor. Lightly and briefly press sharpening lever several times to press the grinding
wheel against the rotating cutter so that it rotates and sharpens the cutter. A clean cut and good
cutting performance can only be achieved with a sharp cutter. Ensure that the countercutter
always rests against the outside edge of the cutter.
Approx. 140 W
Approx. 8000 rpm
Approx. 1000 rpm
80 mm
Approx. 72 mm
Approx. 27 mm
Approx. 2200 g
< 2.5 m/s
73 dB(A)
measured at a distance of 1 m when idling
5
BOM 30 / BOM 30S