Basic Operation; Indicator Lights - Newskill ICARUS IC27F6-V2Z Bedienungsanleitung

5.Basic Operation

EN
1. Insert one end of the DP cable into your PC's graphics card. A HDMI cable may also be used. A HDMI cables is not included.
2. Connect the other end of the cable to the corresponding connector on your monitor.
3. Connect the power cable to your monitor then connect the other end to your power source. It is recommended that you
use a surge protector with adequate voltage if a wall outlet cannot be reached directly.
4. Press the power button to turn on the monitor.

6. Indicator Lights

Solid blue light indicates power is on and the monitor is operating normally. Flashing blue light indicates no video
source ,no horizontal or vertical signal has been detectde or voltage is low. Please ensure your computer is on and all
video cables are fully inserted and/or connected.
10
ICARUS SERIES
HDMI Connector
DP Connector
Indicator light