Wall Mounting - Newskill ICARUS IC27F2-V2P Bedienungsanleitung

4. Wall Mounting

Open the package, take out the product with foam still attached, and gently place it on a desktop or table. Remove the extra
1
parts and the foam covering the back of the monitor. Pree the release button to remove the stand plate. If the monitor
was already attached to the stand, remove the stand.
Remove the original screws x4 (
2
opening in the back of the monitor.
Do not discard the original screws. These may be needed for future use.
Follow the directions received with your mount,
4
stand, or accessory and install the monitor on the
wall or fixture as desired.
This monitor only includes screws which may be used when attaching the
monitor to a VESA 75*75mm type mount. No VESA mount or mounting
accessory is included.
Follow the directions received with your mount, stand, or
3
) from the
accessory and install the monitor on the wall or fixture as desired.
Remember to use the included 4 screws when mounting the
monitor. Refer to the image (
ICARUS SERIES
) for correct screw placement.
17