Duo Collection GAME-ROCKER GT-35 Originalbetriebsanleitung Seite 39

Remarks
1. Connect the load wire at first, following by the power wire; Please
ensure short circuit can not occur between connecting wire before
you turn on the power.
2. Power supply voltage range is DC 12V, 2A, more than voltage
range maybe will burn out the controller;
3. Load connect must according to the connect diagram. During as-
sembly please make sure that no cables are kinked or crushed.
4. When not use it, do not put the remote on easy shake place, to
extend the battery life.
General
Please read and keep these instructions for future reference
These original instructions belong to this desk. They contain
important information about initial set up and handling.
Please read through these original instructions carefully,
particularly the safety instructions before using the desk.
Failure to follow these original instructions could lead to
serious injury, or damage to the desk.
The original instructions are based on standards and
regulations applicable in the European Union. Please observe
other country specific regulations and laws in other countries!
Please keep these original instructions for future reference,
If you pass the desk on to any third party, please be sure to
give them these original instructions.
39