Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A HARDWARE TOUR
TOP VIEW
0 Function switch
ON OFF
This switch is used to check the device before shipment,
and its setting should never be changed.
SCSI mode selection switch
OFF: SCSI-2 mode; burst transmission rate: 10 MByte/sec
ON: SCSI-3 mode; burst transmission rate: 20 MByte/sec
This switch is set off (SCSI-2 mode) at the time of shipment from the factory.
NOTE:
Ordinarily, we recommend using this unit with this switch left off (SCSI-2 mode).
If this switch is set on (SCSI-3 mode), the unit could malfunction, depending on
the connecting cables, usage environment, etc.
TO INSTALL THE DRIVE
For instructions on how to open the
a c c e s s d o o r s , s e e t h e o p e r a t i n g
instructions for the DRM-7000 disc
changer.
Before installation, be sure to specify the
following settings at the rear of each drive
to be installed.
SCSI ID assignment
Specify the SCSI IDs to be used so as
to ensure that the same SCSI ID is not
assigned by more than one drive on the
same SCSI bus.
Termination
Set the termination switch of the last
drive in the SCSI chain to the ON
position.
8
<DRC1137>
En
0
Warning about static electricity
Always be sure never to touch the
contacts or ports when operating
drives.
Also be sure to touch a metallic surface
on the changer before installing
additional drives to the changer.
Werbung
Inhaltsverzeichnis
